Toyota Front Bump Stops 0-3in.

For 00-06 Tundra, 01-22 Sequoia, 98-22 Land Cruiser

• Size:2.5 dia. x 1.75 in (ea.)
• Weight:17 oz. / 1.06 lbs. (set)
• Lift Height:0 3 in.
• Deflection (compression): 0.3 in. @ 1500LBS.

DuroBumps are designed to provide smooth, progressive dampening for your truck suspension, greatly reducing hard bottom-outs. Proudly made in the USA, DuroBumps are made with dual durometer (hardness) rubber, eliminating the typical shell-shock effect of OEM bump stops and providing much greater control and comfort.

The DuroBumps DBF17T is intended to replace the rear-mounted OEM bump stops on the front passenger and driver sides of the truck. The DBF17T will not limit wheel up-travel. Its slightly taller than OEM bump stops, allowing it to compress under load to reduce impact just prior to the ultimate stop.

Features and Benefits

• Improved handlingDual durometer (hardness) rubber allows DuroBumps to act as secondary coil springs that increase compression loads progressively in a smooth, predictable fashion.
• Mounts in OEM location Easily bolts into the OEM mounting location with no modifications required, ensuring a secure fit.
• No loss of up-travel DuroBumps will not reduce suspension/wheel travel.
• Increased suspension life DuroBumps greatly extend the service life of the other suspension components by reducing bottom-outs. DuroBumps absorb the impact, saving critical suspension components from excessive wear and extending service intervals for shocks, ball joints, and control arm bushings.
• Reduced bump steer By absorbing the suspensions up-travel inertia, DuroBumps greatly reduce the energy applied through the tie-rod ends and steering rack. This lessens the shock load and wear and tear on the inner and outer tie-rods, steering rack, and steering-rack bushings.
• Small, compact, application-specific Designed to fit specific truck models: no universal-fit spacers required and no loss of wheel/suspension up-travel.
• Smooth and silent Unlike Hydro bumps, DuroBumps are whisper-quiet on contact.
• Solid mounting base A 3/16 steel base plate provides strong support for DuroBumps and helps ensure solid mounting. The base plate is powder-coated to help prevent corrosion
• Premium bump stops DuroBumps are proudly made in the USA, using the highest quality raw materials.
• Provided mounting hardware Every set of DuroBumps comes with JIS 10.9 zinc-coated hex head metric bolts and a single-use thread locker, ensuring a strong, secure fit.

Note:For off-road use only. By installing these aftermarket bump stops, the user assumes all risk and liability. DuroBumps are not designed for towing applications. Seller will not be held liable for any damages or loss associated with the installation or use of this product for any reason.