RZR Ride Command Amplifier Harness – No Remote Wire

RZR Ride Command Amplifier Harness – No Remote Wire

This Ride Command Plug is designed to provide the RCA low level audio output needed to operate an amplifier on the Polaris factory source unit. It works on both 2 and 4 seat models and is intended for audio use only, without a built-in Remote Out.

• Factory Plug AMP1 (labeled) provides the front output, full range, and is controlled by front on Ride Command
• Factory Plug AMP2 (labeled) provides the rear output, full range, and is controlled by rear on Ride Command
• Factory Plug AMP3 (labeled) provides a full range output, but is not independently controlled by Ride Command and has no on-screen adjustments. It’s a suitable option for a subwoofer.

Tip: For installations where a subwoofer is being installed without a sub control knob, and there’s no need for a front to rear fader for the highs, the rear output can be used as a sub channel. By fading front to rear, some control over the subwoofer level can be achieved. Fading to the front produces less sub output, while fading to the rear produces more sub output by lowering fronts.

“`